Weider WEBE63990 - Manual (Page 12)

12
ADJUSTING THE BACKREST
The Backrest (15) can be adjusted to a level position and
several decline and incline positions.
To increase the incline of the Backrest (15), simply pull up
on the Backrest until the tube on the Backrest Adjustment
Bracket (39) locks into the desired tab on the Bench
Frame (5). To decrease the incline, pull up slightly on the
Backrest, swing out the Backrest Adjustment Bracket and
then lower the Backrest until the Adjustment Bracket locks
into the desired tab on the Frame.
39
Tube
5
Adjustment
Tab
15
WARNING: Always make sure the tube on the back-
rest adjustment bracket is securely locked into one
of the adjustment tabs on the bench frame before
putting any weight on the backrest.
ATTACHING WEIGHTS TO THE LEG LEVER
To use the Leg Lever (18), slide the desired amount of
weight onto the weight tube.
18
13
Weight Tube
WARNING: Do not place more than 150 pounds on
the leg lever. Always secure the weights with a
Weight Clip (13) when you have mounted them on
the leg lever, barbell or curl barbell.
ATTACHING THE CURL POST
For some exercises, the Curl Post (42) must be attached
to the weight bench.
Insert the Curl Post (42) into the indicated hole in the
Front Leg (19). Align the holes in the Front Leg and the
Curl Post. Secure the Curl Post with the Adjustment Knob
(36). Make sure that you fully tighten the Adjustment
Knob.
36
42
19
WARNING: When the curl post is not in use, store it
away from the bench, so it will not interfere with
the next exercise you perform.
SETTING UP THE BENCH FOR SQUAT EXERCISES
When performing squat exercises, place the Weight
Rests (21) into one of the upper sets of adjustment holes
in the two Uprights (1). Place the Safety Spotters (26) a
few holes lower, so they can catch the barbell, if you acci-
dentally drop it.
21
26
1
1
21
26
WARNING: Always move the bench when you are
performing standing exercises in the cage. Stand
inside the area that is shaded in the drawing.