Important safeguards – West Bend MCD 289 User Manual
Page 2
2
IMPORTANT SAFEGUARDS
To prevent personal injury or property damage, read and follow all instructions
and warnings.
When using electrical appliances, basic safety precautions should always be
followed including the following:
•
Read all instructions, including these important safeguards and the care and use
instructions in this manual.
•
Do not use appliance for other than intended use.
•
The use of accessory attachments not recommended by Focus Electrics may
cause fire, electric shock or injury.
•
Do not operate if the blender is not working properly or if it has been damaged in
any manner. For service information see warranty page.
•
Do not leave unit unattended while plugged into an electrical outlet.
•
Keep hands and utensils out of the blending jar while blending to reduce the risk
of severe injury to persons or damage to the blender. A scraper may be used
but must be used only when the blender is unplugged and not in operation.
•
Do not attempt to repair this appliance yourself.
•
Blades are sharp. Use extreme caution during assembly, while operating,
disassembly and cleaning.
•
Do not use if blades are broken, cracked or loose.
•
Always operate blender with lid in place.
•
Always hold blending jar while processing for stability.
•
Do not leave blender unattended while it is operating.
•
Do not remove blending jar from base until the motor has stopped completely.
•
Do not use a cracked, chipped or broken blending jar.
•
When blending hot liquids, remove lid cap.
•
Avoid contacting moving parts.
•
To reduce the risk of injury, never place cutting assembly blades on motor base
without blending jar properly attached.
•
Do not use this appliance on the stovetop, under broiler, in the oven, in the
refrigerator or freezer.
•
To protect against electric shock, do not immerse cord, plugs, or other electric
parts in water or other liquids.
•
Do not operate any appliance with a damaged cord or plug.
•
Do not use this appliance outdoors.
•
Do not plug cord into wall outlet unless power switch is in “OFF” position.
•
Always turn control to “OFF” and unplug the appliance from outlet when not in
use, before cleaning. Allow to cool before putting on or taking off parts and
before cleaning.