Whistler PRO-3450 - Manual (Page 11)

COMMUNICATION BREAKDOWN
Communication Breakdown
If a problem arises between the inside control panel and
the outside antenna, the unit will give a unique audio tone.
The display reads:
If a R error occurs:
• Press P/V to turn unit off.
• Check connection in back of control panel.
• Perform “reset features.”
• See dealer/installer.
If a T error occurs:
• Press P/V to turn off unit.
• Check connection in back of control panel.
• See dealer/installer.
NOTE: This T error occurs only at Power Up.
19
RESET FEATURES/CARE & MAINTENANCE
18
Reset Features
All user features can be reset to factory settings.
• Remove Power from unit.
• Press and hold P/V and Quiet.
• Apply power to the unit.
• Wait for 2 beeps.
• Release P/V and Quiet. Unit is now reset.
1. Audio to level (5).
2. Display reads Highway.
3. Dim/Dark Mode to full illumination of display.
4. Auto Quiet Mode OFF.
5. VG-2 Detection Mode OFF.
6. Voice OFF.
7. POP
™ Mode ON.
8. Safety OFF.
9. Full Power Up sequence.
10. Default TONE 3.
11. BATT OFF.
12. TEMP OFF.
13. Display to Normal orientation.
14. Unit ON or OFF.
Care And Maintenance
Do not spray water, cleaners or polishes directly onto the
unit. The spray may penetrate through the openings and
damage the unit. Also, do not use any abrasive cleaners on
the unit’s exterior.
Pro-3450_OwnersManual.qxd 3/15/04 4:30 PM Page 21