Wolverine 8000 - Manual (Page 2)

2
FCC Certifications
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. ©These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced technician for help.
27
Step 2: To avoid bending the pins, carefully slide the battery into the chassis.
Note: If you are using the NP-60 battery, you will find a spongy rubbers
underneath the front cove, this is to secure the assembly.
4
Dear Customer,
Thank you for purchasing the FlashPro 8000.
Before using the FlashPro 8000, you will have to
1 Charge the battery
2 Install FlashPro 8000 Windows 98 USB driver
(If you are a Windows 98 user)
3 Keep FlashPro 8000 plugged into the AC adapter/charge
while connected to your computer.
4 Check www.Wolverinedata.com to download any update
firmware that may offer new features .
Wishing you all the best
The Wolverinedata Team
25
Problems Formatting, and partitioning
To work in the stand-alone mode, both the disk and the memory cards
must be formated to the FAT or FAT-32 file systems.
Note: Win 2000/ Win XP can not support Format Disk for 32G
above Hard Drive.
Solutions
To have the 32G above Hard Disk work on the Win 2000/Win XP,
youcan use the included FDisk Application Program to format the HDD.
Problems The amount of free HD space on my FlashPro 8000 is different
from the PC.
Solutions Run Scandisk to correct the disk platters for defects and also looks for
lost clusters that are sometimes created when a program aborts.
It is recommended to safely disconnect the FlashPro 8000 ( Refer to
3-3 )