Disassembling the charging dock, Getting started – Wow Wee Rovio 8033 User Manual

Page 12

Advertising
background image

12

4. Two red dots will project light onto the ceiling. To optimize the signal, point

the red dots at the center of the ceiling away from unsmooth surfaces such as
lighting fixtures, fans, air vents and corners.

NOTES:

The red dots are a guide to help you set up the charging dock. If the light turns
off while you are positioning the dots, touch the metal rim to reactivate it. During
normal operation the red light will not be lit.

In order for Rovio to be able to self-dock and recharge, you must power the charging
dock at all times.

Important battery information

Use only fresh batteries of the required size and recommended type.

Rechargeable batteries are only to be charged under adult supervision.

Respect the correct polarity, (+) and (-).

Do not throw batteries into the fire.

The supply terminals are not to be short-circuited.

Batteries should be replaced by adults.

Remove batteries if the product is not going to be used for some time.

This user manual should be kept because it contains important information.

Disassembling the charging dock
To disassemble the charging dock:

1. Unplug the power cable from the back of the charging dock and from the

electrical outlet.

2. Turn the charging dock over and locate the two tabs that hold the mast in

place. Using two fingers, squeeze both tabs towards each other and remove
the mast

Getting started

Assembling the charging dock / Disassembling the charging dock

Advertising