Well Traveled Living Outdoor Patio Heater LIP-10A-TGG-LPG-SP - Manual (Page 8)

- 8 -
7. Assemble Reflector Panels (A) with Reflector Center Cap (B).Reflector
Panels (A) come packaged in two brown boxes with two panels in each
box. Hardware for assembly is already affixed to each panel. Place two
panels side by side and remove the two cap nuts and washers that are
affixed to one panel. Insert the affixed bolts into the open holes on the
adjacent panel. Place the washer over the bolt and screw on cap nut.
Repeat these steps until all four panels are assembled. Then locate the
Reflector Center Cap (B). You will need to remove the cap nuts and
washers located at the top of each Reflector Panel to allow assembly
of the Center Cap on each panel. Align the holes in the Center Cap with
the bolts on each panel and affix washer and cap nut to complete
assembly.
8. While supporting heater, tilt the Head Assembly (C) and slide the assembled
Reflector over the 3 bolts that extend from the Head Assembly. Use the
3 M8 Wing Nuts (EE) and 3 M8 Washers (GG) to secure the assembled
Reflector to the Head Assembly of the heater. Once you have tightened the
Wing Nuts, return the heater to an upright position.
Hardware Used: 3 x EE, Wing Nut M8
3 x GG, Washer M8
9.
Connect the hose and regulator to the LP cylinder. The LP cylinder is
sold separately. Use a standard 20 lb. propane cylinder only. Lift the
Tank Housing (D) up and rest it on the top of the assembled Post Supports (I).
Screw Regulator (G) onto Gas Hose (E). Do not cross thread. Hand tighten securely.
Attach Regulator (G) to valve on LP cylinder and hand tighten securely.
Place LP tank onto base of heater and lower
Tank Housing.
NOTE: Use this heater only with a propane
vapor withdrawal supply system. See chapter 5 of
the standard for storage and handling of liquefied
petroleum gas, ANSI/NFPA 58. Your local library or
fire department should have this book.
ASSEMBLY
7
8
9