Weider WESY29510 - Manual (Page 12)

12
21
Bracket
10
45
41
44
74
84
23
24
84
94
58
13
4
44 86
70
42
45
92
86
70
42
Ball
41
75
25
81
82
26
83
22
41
25
82
21. Route the Long Cable (41) over a 3 1/2” Pulley
(45). Attach the Pulley and a Cable Trap (44) to
the bracket on the Top Frame (10) with a 3/8” x 2”
Bolt (74) and the 3/8” Nylon Locknut (84). Be
sure that the Cable is in the groove of the
Pulley and that the Cable and Pulley move
smoothly.
22. Attach the Long Cable (41) to the Small “U”-
Bracket (25) with a 1/4” Nylon Locknut (82) and a
1/4” Washer (81). See the inset drawing. Do not
overtighten the Nylon Locknut; it should be
threaded onto the end of the Cable only two
turns, as shown.
Attach the Small “U”-Bracket (25) to the Weight
Tube (26) with the 5/16” x 1 3/4” Bolt (75) and a
5/16” Nylon Locknut (83).
23. Locate the Short Cable (42). Route the Short
Cable under a Pro 3 1/2” Pulley (94). Attach the
Pulley and the 5/8” x 9/16” Spacer (58) to the
lower hole in the Press Frame (13) with a 3/8” x 3
3/4” Bolt (70), a 3/8” Washer (86), and a 3/8”
Nylon Locknut (84). Be sure that the end of the
Cable with the ball is on the indicated side of
the Pulley.
24. Wrap the Short Cable (42) around a 3 1/2” Pulley
(45). Attach the Pulley and a Cable Trap (44) to
the lower hole in the Front Upright (4) with a 3/8”
x 3 3/4” Bolt (70), a 3/8” Washer (86), and a 3/8”
Nylon Jamnut (92). Be sure that the Cable Trap
is turned to hold the Cable in place and that
the Cable is routed around the Pulley as
shown.