weber Platinum C - Manual (Page 13)

B-2
Installing the warming rack
You will need: warming rack.
Set the warming rack into the slots at the rear of the
cooking box.
Installing the Warm-Up™ Basket
You will need: Warm-Up Basket
Insert one end of the Weber Warm-Up Basket into the hole
at the right side of the inside of the lid, and the other end
into the slot at the left side of the lid.
Install the bottom shelf
You will need: Bottom shelf.
Set the bottom shelf in place between the two frame
connectors underneath the cooking box.
(1) (2)
Install Left Work Surface
You will need left work surface, two 1/2 inch bolts, two
nylon washers and a 7/16 inch or adjustable wrench.
Insert the left work surface tabs in the slots in the frame(1).
Slip washers on the bolts and insert the bolts as shown(2).
Tighten
Check that all burner valves are off
You will need: burner control knobs.
Valves are shipped in the OFF position, but you should
check to be sure that they are turned OFF. Put the knob on
each valve. Check by pushing down and turning clockwise.
If they do not turn, they are off. Proceed to the next step. If
they do turn continue turning them clockwise until they
stop, then they are off. Proceed to the next step.
Check that the side burner valve is in the OFF position.
Push in and turn to OFF.