Whirlpool 240-volt - Manual (Page 9)

9
Three-Wire Electrical Connection to Receptacle
• Do not use an extension cord with
this dryer.
• Do not connect plug end of power supply
cord into a live receptacle before
connecting power supply cord to dryer
terminal block.
Local codes may permit the use of a U.L.-
listed, 120/240-volt minimum, 30-ampere,
dryer power supply cord kit (pigtail). Power
supply cord should be type SRD or SRDT
and be at least four feet long. The wires that
connect to the dryer must end with ring
terminals or spade terminals with upturned
ends.
NEUTRAL
This blade connected
to this conductor
NEUTRAL
(white or center)
3 ⁄
4
", U.L.-listed,
strain relief
Spade terminals
with upturned ends
Ring
terminals
• The power supply cord must have three,
No.-10 copper wires to match a three-wire
receptacle of NEMA Type 10-30R.
INSTALLATION INSTRUCTIONS
GROUNDING INSTRUCTIONS
This appliance must be grounded.
In the event of malfunction or breakdown,
grounding will reduce the risk of electric
shock by providing a path of least
resistance for electric current. The power
supply cord must be plugged into an
appropriate outlet that is properly installed
and grounded in accordance with all local
codes and ordinances.
WARNING: Improper connection of the
equipment-grounding conductor can result
in a risk of electric shock.
Check with a qualified electrician or
serviceman if you are in doubt as to
whether the appliance is properly
grounded. Do not modify the plug on the
power supply cord. If it will not fit the
outlet, have a proper outlet installed.
SAVE THESE INSTRUCTIONS
Three-wire
receptacle (NEMA
Type 10-30R)
w WARNING
Fire Hazard
Use a new UL approved 30 ampere
power supply cord.
Use a UL approved strain relief.
Disconnect power before making
electrical connections.
Connect neutral wire (white or center
wire) to center terminal (silver).
Ground wire (green or bare wire) must
be connected to green ground
connector.
Connect remaining 2 supply wires to
remaining 2 terminals (gold).
Securely tighten all electrical
connections.
Failure to do so can result in death,
fire, or electrical shock.
3977625v09c27 4/1/99 4:45 PM Page 9