weber Summit 92774 - Manual (Page 6)

6
LIGHTING
1) Open the lid. Figure 1.
2) Make sure all burner control knobs are OFF. (Push
each burner control knob down and turn clockwise.)
3) Turn on gas supply.
ƽ
WARNING: Do not lean over open barbecue. Keep
your face and body at least one foot away from the
matchlight hole when lighting the barbecue.
4) Select Heat Zone.
5) Push LEFT burner control knob down and turn to
START/HI.
6) Push the Crossover Ignition Button several times, so
it clicks each time.
7) Check that the burner is lit by looking through the
matchlight hole above the burner control knob.
ƽ
WARNING: If the burner does not light, turn the LEFT
burner control knob to OFF and wait 5 minutes to let the
gas clear before you try again or try to light with a match.
8) After the LEFT burner is lit you can turn on the
RIGHT burner.
Note - Always light the LEFT burner first. The RIGHT
burner ignites from the LEFT burner.
TO EXTINGUISH
Turn gas supply OFF at the source, then push down
and turn each burner control knob clockwise to OFF.
EACH HEAT ZONE OPERATES INDEPENDENTLY.
Summary lighting instructions are on the control panel.
ƽ
DANGER
Failure to open lid while igniting the
barbecue, or not waiting 5 minutes to
allow the gas to clear if the barbecue does
not light, may result in an explosive flame-
up which can cause serious bodily injury
or death.
High Medium Low Off
Crossover Ignition System
Note - The Crossover Ignition System ignites the Left
burner of each heat zone with a spark from the igniter
electrode inside the Gas Catcher Ignition Chamber. You
generate the energy for the spark by pushing the
Crossover Ignition Button until it clicks.
ƽ WARNING: Check hose before each use of
barbecue for nicks, cracking, abrasions or cuts. If the
hose is found to be damaged in any way, do not use
the barbecue. Contact your dealer.
ƽ WARNING: The storage space under the cooking
module is intended for storage of nonflammable
items only.