WORX Tools WU433 - Manual (Page 10)

10
MOUNTING
Clean the saw blade and all the clamping parts to be assembled. Tilt
back the lower blade guard (9) and hold it firmly with the lower guard
lever (11). Place the saw blade onto the inner flange (15). Assemble
the outer flange (17) and the blade bolt (18). Use the spanner (19) to
tighten the bolt (18) with 1/4 turn more than finger tight.
• Take care that the mounting positions of the inner flange (15)
and outer flange (17) are correct.
• When mounting: Ensure that the cutting direction of the
teeth (direction of arrow on saw blade) and the direction-of-
rotation arrow on the blade guard match.
DUST/CHIP EXTRACTION (See Fig.E)
Fasten the vacuum adapter (22) onto the dust extraction outlet (12)
until it latches. Additionally fasten the vacuum adapter (22) to the
fixed guard (13) with the two screws. Directly connect a suitable
vacuum hose to the adapter.
• The vacuum adapter must not be mounted when no external
dust extraction is connected. Otherwise there is danger of the
extraction system becoming clogged.
Clean the vacuum adapter regularly to ensure optimum dust
extraction. The vacuum cleaner must be suitable for the material to
be worked. 6
The cutting mark 0° indicates the position of the saw blade for right-
angled cuts.
Note: It is best to carry out a trial cut.
SWITCHING ON AND OFF
Depress the On/Off switch (1) to start the saw and release to stop.
For safety reasons the On/Off switch (1) of the machine cannot
be locked; it must remain pressed during the entire operation.
CHANGING THE SAW BLADE (See Fig.A)
• Before any work on the machine itself, pull the mains plug.
• Wear protective gloves when mounting the saw blade. Danger
of injury when touching the saw blade.
• Only use saw blades that correspond with the characteristic
data given in the operating instructions.
• Do not under any circumstances use grinding discs as the
cutting tool.
For changing the cutting tool, it is best to place the machine on the
face side of the motor housing.
REMOVING
Press the spindle lock button (3) and keep it depressed.
• The spindle lock button (3) may be actuated only when the saw
blade is at a standstill.
Loosen the blade bolt (18) with the spanner (19). Remove the outer
flange (17). Tilt back the lower blade guard (9) and hold it firmly with
the lower guard lever (11). Remove the saw blade (16).
4
5