weber Summit 56069 - Manual (Page 19)

IGNITER
If the Ignition system fails to ignite the side burner, light the burner with a match.
• Check that both ignition wires are attached properly.
• You should hear the igniter sparking.
REPLACE BATTERY IF NECESSARY
AAA alkaline battery only. See illustration:
If the Electronic Ignition System still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site.
Log onto www.weber.com
® .
WWW.WEBER.COM ®
19
SIDE BURNER MAINTENANCE
ƽ WARNING: All gas controls and supply valves should be in
the “OFF” position.
Make sure ignition wires(1) are connected between the igniter and electrodes.
Make sure grounding wire(2) is connected between the igniter and grounding clips on
the burner cups.
Spark should be a white/blue color, not yellow.
1) Igniter
Wires
2) Ground wire
3) Burner
PROBLEM CHECK CURE
Side Burner does not light. Is gas supply off?
The excess flow safety device, which is part
of the barbecue to cylinder connection, may
have activated.
Turn supply on.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to
START/HI. Wait at least 1 minute. Turn burner control knobs to “OFF”. Reconnect
the regulator to the cylinder. Turn cylinder valve on slowly. Refer to “Lighting
Instructions”.
Flame is low in “HI” position. Is the fuel hose bent or kinked? Straighten hose.
Push button ignition does not work. Does burner light with a match? If match lights burner, check igniter (see Sideburner Maintenance).
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
® .
SIDE BURNER TROUBLESHOOTING
1
1
2 3
GENERAL MAINTENANCE