Winegard LP-1000 - Manual (Page 6)

6
3. INSTALLATION
3.1 Installation Overview:
1. Gather the tools and materials required for installation
2. Unpack and inspect RoadTrip LP
3. Select a location to mount the antenna. .
4. Mount the antenna system
5. Adjust the antenna switch settings
6. Route and connect coax and wires.
3.2 Tools and Material Required for Installation:
1. Drill
2. ½” drill bit
3. 1¼” hole saw (if mounting switch in wall)
2. Tape measure
3. Wire cutter/stripper for 16 AWG wire
4. RG-6 connector crimp tool
5. RG-6 coax stripping tool
6. 7/16” open-end wrenches
7. Phillips #2 Screwdriver
8. 1/2” open-end wrench
9. Level
10. Sealant (check with RV manufacturer for proper type for
your roof material)
3.3 Unpack and Inspect the RoadTrip LP
When you receive your antenna, inspect for any
damage that may have occurred during shipping. To safely
remove the unit from the box, use two people. Open box
and carefully remove the unit. The unit will be shipped with
radome attached to protect the unit. RoadTrip LP will also be
shipped with the mounting brackets preattached to the base.
There are no shipping restraints on the antenna to remove.
3.4 Select a Location to Mount the Antenna
Select level location on your roof that has a clear view of the
horizon in all directions. Although the unit can be mounted up
to +/- 3 degrees off level, for fastest acquisition mount
the unit as close to level as possible.
The unit should be kept clear of all obstructions on the roof
(air conditioning units, etc.). If you have an obstruction on
the roof that may interfere with reception, use the following
guidelines for determining the distance from obstruction to
mount antenna.
Plan your entire installation
before you start. Determine the
location of all of your equip-
ment and make sure cable and
wires are long enough to reach
their termination points.
If using a knife to open carton, be careful
not to damage the radome or cables.
Fig 3.1