Water filter certifications – Whirlpool 12828188A User Manual

Page 14

Advertising
background image

14

The water and ice dispenser will not operate properly

■

Refrigerator connected to a water supply and the supply
shutoff valve turned on?
Connect refrigerator to water
supply and turn water shutoff valve fully open.

■

Kink in the water source line? Straighten the water source
line.

■

New installation? Flush and fill the water system. See “Water
and Ice Dispenser.”

■

Is the water pressure at least 35 psi (241 kPa)? The water
pressure to the home determines the flow from the dispenser.
See “Water Supply Requirements.”

■

Water filter installed on the refrigerator? Remove filter and
operate dispenser. If water flow increases, the filter may be
clogged or incorrectly installed. Replace filter or reinstall it
correctly.

■

Refrigerator door closed completely? Close the door firmly.
If it does not close completely, see “The doors will not close
completely.”

■

Recently removed the doors? Make sure the water
dispenser wire/tube assembly has been properly reconnected
at the bottom of the refrigerator door. See “Refrigerator
Doors.”

■

Reverse osmosis water filtration system connected to
your cold water supply?
This can decrease water pressure.
See “Water Supply Requirements.”

Water is leaking from the dispenser system

NOTE: One or two drops of water after dispensing is normal.

■

Glass not being held under the dispenser long enough?
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.

■

New installation? Flush the water system. See “Water and
Ice Dispenser.”

■

Recently changed water filter? Flush the water system. See
“Water and Ice Dispenser.”

■

Water on the floor near the base grille? Make sure the water
dispenser tube connections are fully tightened. See
“Refrigerator Doors.”

Water from the dispenser is warm

NOTE: Water from the dispenser is only chilled to 50°F (10°C).

■

New installation? Allow 24 hours after installation for the
water supply to cool completely.

■

Recently dispensed large amount of water? Allow 24 hours
for water supply to cool completely.

■

Water not been recently dispensed? The first glass of water
may not be cool. Discard the first glass of water.

■

Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to a cold water pipe. See “Water
Supply Requirements.”

WATER FILTER CERTIFICATIONS

Advertising
This manual is related to the following products: