Waterford Appliances EMERALD E63-NG1 - Manual (Page 11)

Waterford E63-1 EMERALD Freestanding Gas Stove 11
Reduction Kit to Lower
Btu Rating for Emerald
E65-1 Gas Stove
Natural Gas - Kit #: 260-920
Propane - Kit # 260-922
T HIS CONVERSION MUST
BE DONE BY A
QUALIFIED GAS FITTER IF
IN DOUBT DO NOT DO
THIS CONVERSION !!
4) Carefully remove the logs, embers and rock-
wool.
5) Remove burner.
Natural Gas Conversion Kit 260-920
Contains:
Qty. Part #
Description
1 904-593 Burner Orifice #40
(Natural Gas)
1 908-365 Decal "Converted to
27,000 Btu"
1 908-363 Instruction Sheet
Propane Conversion Kit 260-922
Contains:
Qty. Part #
Description
1 904-390 Burner Orifice #52 (Propane)
1 908-365 Decal "Converted to
29,000 Btu"
1 908-363 Instruction Sheet
1) Shut off the gas supply.
The wing nut that holds the front door is
accessible through the cut-out in the right
side heat shield.
Note: Use a magnetic type screwdriver
if possible.
INSTALLATION
E63/E65 Conversion Decal: 908-175
Burner Orifice
9) Unscrew the pilot orifice with the allen key
and replace with the LP pilot orifice in the kit.
10) Remove burner orifice with a 1/2" wrench
and discard. Use a wrench to hold on to the
elbow behind the orifice.
11) Reinstall new burner orifice LP stamped
#50 and tighten.
12) Reverse steps 4) to 2).
13) Attach the Conversion label "This unit has
been converted to Propane" on top of the
Serial # decal. E63/E65: Part #175
14) Replace yellow "Natural Gas" label with red
"Propane" label
15) Check for gas leaks.
16) Check inlet and outlet pressures.
17) Check operation of flame control.
18) Check for proper flame appearance and
glow on logs.
2) Open the valve door and remove the control
panel.
3) Open the front door. Open the right side
door and there is a cutout in the heat shield
through which can be seen a wing nut
threaded on to a stud attached to the front
door. Loosen this nut by turning it counter-
clockwise.