Weider WEBE0635.0 - Manual (Page 6)

6
2. Attach the Bench Frame (2) to the Center Frame
(3) with two M8 x 53mm Bolts (38), two M8
Washers (31), and two M8 Nylon Locknuts (30);
and an M8 x 55mm Bolt (37) and another M8
Nylon Locknut (30).
Do not tighten the
Locknuts yet.
4. Set the Adjustment Tube (14) into a set of brack-
ets on the Uprights (4, 5).
Make sure that the
pins on the Adjustment Tube are inserted into
the holes in the brackets.
Tighten the M8 Nylon Locknuts (30) used in
steps 1 and 2.
5. Attach the Weight Tube (8) to the Leg Lever (7)
with an M8 x 45mm Bolt (33), two M8 Washers
(31), the 4mm Spacer (29), and an M8 Nylon
Locknut (30).
Press the 25mm Round Outer Cap (25) onto the
Weight Tube (8).
3. Attach the Front Leg (1) to the Bench Frame (2)
with three M8 x 15mm Screws (34) and three M8
Washers (31).
2
38
38
37
31 30
30
3
2
3
1
2
31
31
31
34
34
34
14
Pin
4
5
4
5
Pin
Hole
25
7
33
31
8
30
31
29