Waterford Precision Cycles Stainless Steel Box Hood - Manual (Page 4)

Digital display,displays the speed of the
fan 1-6
Increases the speed of the fan (Max
speed 6)
OFF delay switch, press once display
flashes, fan switches off automatically
after 10 minutes.
Light ON/OFF switch
If there is an appliance fitted in the vicinity which
requires air for combustion, additional air vents will
be required to alleviate the possibility of spillage of
products of combustion, from the appliance/flue
while the fan is in operation. Refer to B.S. 5440 Part
2 & I.S. 813.
Where such an installation exists a test for spillage
should be carried out with all appliances requiring air
for combustion and all extraction fans running at
maximum rate, (i.e. tumble dryers, extraction fans)
with all external windows and doors closed.
If spillage occurs following the above operation, an
additional air vent of sufficient size to prevent this
occurrence should be installed.
The hood is designed to be wall mounted. Take the
fixing brackets from the packaging and attach them
to the fan unit as shown in Fig. 2 & 3. Remove the
filters from the hood section as shown in (Fig. 5). Fix
the hood section to the fan section using four 10mm
screws (See Fig. 6). Insert the plug on the fan unit
to the socket on the hood section. Position the hood
in the desired position against the wall and mark the
four positions for fixing the two fixing brackets. Drill
four holes at the marked positions using a 6mm
masonry drill bit and insert the rawl plugs into the
holes. Screw the two bottom support screws half
way into the rawl plugs and hook the hood assembly
onto the screws. Fix the hood assembly to the wall
by inserting the two top screws and tighten the bot-
tom support screws. Attach the plastic coupling to
the fan section using two 10mm screws (See Fig.4).
The steel ducting for the hood is to be fixed to the
wall using the bracket supplied, the bracket is to be
fixed nearest the ceiling and fixed to the end of the
duct with slots in it.
VENTILATION
DIMENSIONS
INSTRUCTIONS FOR ASSEMBLY
Fig.1
Wall Fixing
Bracket
THE MANUFACTURER WILL NOT BE RESPONSI-
BLE IF THESE RECOMMENDATIONS AND
INSTRUCTIONS REGARDING INSTALLATION,
MAINTENANCE AND USE ARE NOT OBSERVED
AND RESPECTED WHEN USING THE COOKER
HOOD.
3