Weider WESY39311 - Manual (Page 12)

12
18. Wrap the High Cable (58) around a “V”-Pulley (50).
Attach the “V”-Pulley and a Long Cable Trap (31) to
the indicated bracket on the Front Upright (42) with
a 3/8” x 2 1/2” Bolt (86) and a 3/8” Nylon Locknut
(21). Be sure that the Long Cable Trap is posi-
tioned to hold the Cable in place.
19. Route the High Cable (58) around the “V”-Pulley
(50) on the Left Arm (47). Be sure that the Cable
is in the groove of the Pulley and that the Long
Cable Trap (31) is positioned to hold the Cable
in place. Tighten the 3/8” x 2 1/2” Bolt (86) and the
3/8” Nylon Locknut (not shown).
20. Route the High Cable (58) around the “V”-Pulley
(50) on the Right Arm (48). Be sure that the Cable
is in the groove of the Pulley and that the Long
Cable Trap (31) is turned to hold the Cable in
place. Tighten the 3/8” x 2 1/2” Bolt (86) and the
3/8” Nylon Locknut (not shown).
21. Attach the Pulley Bracket (20) to the Top Frame
(55) with the 5/16” x 5” Bolt (68) and a 5/16” Nylon
Locknut (3). Do not over tighten the Nylon
Locknut; the Pulley Bracket must be able to
move freely.
See the inset drawing. Route the High Cable (58)
around the 3 1/2” Pulley (15) attached to the Pulley
Bracket (20). Tighten the 3/8” x 2” Bolt (12) and the
3/8” Nylon Locknut (not shown). Be sure that the
Cable is in the groove of the Pulley and that the
Cable Trap (66) is turned to hold the Cable in
place.
21
18
86
86
31
31
50
50
21
58
58
19
20
42
47
86
31
50
58
20
68
3
55
48
Bracket
58
15
66
12