Weider WEBE09140 User Manual
Page 6
6
3
4
4.
Attach a Support (4) to a Stabilizer (1) with the
two indicated M8 x 68mm Carriage Bolts (20) and
two M8 Nylon Locknuts (22).
Do not tighten the
Locknuts yet.
Attach the Support (4) to the Upright Base (2)
with two M8 x 75mm Bolts (17), two M8 Washers
(23), and two M8 Nylon Locknuts (22).
Do not
tighten the Locknuts yet.
Attach the other Support (4) to the other
Stabilizer (1) and Upright Base (2) in the same
manner.
29
2
10
22
22
20
1
1
22
22
20
17
23
23
22
22
2
4
2
13
22
3.
Attach the Bottom Crossbar (10) to an Upright
Base (2) with two M8 x 77mm Bolts (29), a
Support Plate (13), and two M8 Nylon Locknuts
(22).
Note: Attach the Bottom Crossbar so that
the indicated warning decals are in the indi-
cated locations. Do not tighten the Locknuts
yet.
Attach the Bottom Crossbar (10) to the other
Upright Base (2) in the same manner.
2
2
Hexagonal
holes on
this side
Decal
Decal
2.
Attach an Upright Base (2) to a Stabilizer (1) with
the indicated two M8 x 68mm Carriage Bolts (20)
and two M8 Nylon Locknuts (22).
Note: Attach
the Upright Base so that the hexagonal holes
are on the indicated side. Do not tighten the
Locknuts yet.
Attach the other Upright Base (2) to the other
Stabilizer (1) in the same manner.