Wacom DTF-720 User Manual

Page 40

Advertising
background image

Troubleshooting
Page 38

Double-clicking is difficult.

Be sure you are quickly tapping the display screen twice in the same
place on the pen display tablet’s active area. Wacom recommends
using the side switch to double-click.

Open the Pen Tablet control panel and go to the P

EN

tab.

Try increasing the D

OUBLE

C

LICK

D

ISTANCE

or using a lighter T

IP

F

EEL

.

Windows: Try setting your system to launch programs with a single
click. See Pen operations on page 18.

You notice a delay at the
beginning of pen strokes.

Open the Pen Tablet control panel and go to the P

EN

tab.

Try decreasing the D

OUBLE

C

LICK

D

ISTANCE

.

You have to press hard with
the pen when clicking,
drawing, or writing.

Open the Pen Tablet control panel and go to the P

EN

tab. Move the

T

IP

F

EEL

slider toward S

OFT

.

The pen tip does not
function.

Be sure you are using the pen that originally came with your pen
display tablet. Other pens may not function properly on the DTF-720
pen display.

Make sure the status LED lights blue when the tip is pressed. If the
LED does not light, verify that the USB cable is plugged into an active
port on your computer or on a USB hub.

If the LED still does not light, you may have defective hardware (see
Troubleshooting on page 33).

The side switch does not
work.

Be sure you are using the pen that originally came with your pen
display tablet. Other pens may not function properly on the DTF-720
pen display.

Be sure you press the side switch when the pen tip is within 5 mm
(0.2 inch) of the pen display’s active area – do this without pressing
down on the pen tip.

From the Pen Tablet control panel, verify that the side switch is set to
the proper function you are expecting to occur.

Make sure the status LED lights blue when you press the side switch.
If the LED does not light, verify that the USB cable is plugged into an
active USB port on your computer or on a USB hub; the LED will not
light if the USB cable is not plugged into an active port.

If the LED does not light, you may have defective hardware (see
Troubleshooting on page 33).

DTF720_Manual.fm Page 38 Monday, December 22, 2008 9:17 AM

Advertising