Western Telematic IPS-800 - Manual (Page 37)

5-19
Confi guration
Figure 5.14: Web Server Parameters Menu - Web Browser Interface
WEB SERVER:
1. Service: On
2. Server Port #: 80
Enter Selection,
Press <ESC> to Exit ...
Figure 5.15: Web Server Parameters Menu - Text Interface
5.3.6. Web Server Parameters Menus
The Web Server Parameters Menus are used to configure the internal web
server, which allows the unit to be operated via the Web Browser Interface.
• Web Browser Interface: Click the "Setup" button to access the
configuration menus, and then click the Web Server Parameters button.
The Web Server Parameters Menu will be displayed as shown in
Figure 5.14.
• Text Interface: Type /W and press [Enter]. The Web Server Parameters
Menu will be displayed as shown in Figure 5.15.
The Web Server Parameters Menu allows you to define the following:
• Service: Enables/Disables the IPS’s Web Server. Note that when the
Web Server is disabled, you will not be able to communicate via the Web
Browser Interface. (Default = On.)
• Port Number: Sets the TCP/IP Port Number. The Port Number can be
set to any valid number except 23; this is because 23 is the default port
number that is used for communication with the unit via Telnet.
(Default = 80.)