Weider WESY39310 User Manual
Page 13
13
22. See the inset drawing. Attach a 3 1/2” Pulley (15)
and a Cable Trap (66) to the upper hole in a Long
“U”-Bracket (57) with a 3/8” x 2” Bolt (12) and a 3/8”
Nylon Locknut (21).
Be sure that the Cable Trap is
inside the Long “U”-Bracket. Note: This may
come pre-assembled.
Route the High Cable (58) through the Long “U”-
Bracket (57) and the 3 1/2” Pulley (15) shown in the
inset drawing.
Be sure that the Cable is in the
groove of the Pulley and that the Cable and
Pulley move smoothly.
23. Wrap the High Cable (58) around a 3 1/2” Pulley
(15). Attach the Pulley to the bracket on the Top
Frame (55) with a 3/8” x 2” Bolt (12) and a 3/8”
Nylon Locknut (21).
Be sure that the Cable is in
the groove of the Pulley and that the Cable and
Pulley move smoothly.
24. Attach the High Cable (58) to a Small “U”-Bracket
(71) with a 1/4” Nylon Locknut (2) and a 1/4” Washer
(10).
Do not completely tighten the Nylon
Locknut. It should be threaded onto the end of
the Cable only a couple of turns, as shown in the
inset drawing.
Attach the Small “U”-Bracket (71) to the indicated
Weight Tube (63) with a 5/16” x 1 3/4” Bolt (24) and
a 5/16” Nylon Locknut (3).
22
58
15
15
66
21
12
57
Bracket
55
21
12
15
58
23
58
57
58
24
71
10
2
24
3
58
10
2
71
63