Weider Pro 240 831.150312 - Manual (Page 8)

8. Insert the Backrest Bracket (10) into the slot in
the Bench Frame (1).
Lubricate an M10 x 168mm Bolt (41) with grease.
Attach the Backrest Tubes (12) to the Bench
Frame (1) with the Bolt and an M10 Nylon Locknut
(48).
Do not overtighten the Locknut; the
Backrest Tubes must be able to pivot easily.
8
6
48
34
51
47
30
47
42
56
Lubricate
16
3
2
6. Attach the Weight Tube (16) to the Leg Lever (3)
with an M8 x 58mm Bolt (42), two M8 Washers
(47), a 10mm Spacer (30), and an M8 Nylon
Locknut (51). Press a 25mm Round Angled Cap
(34) onto the end of the Weight Tube.
Lubricate an M10 x 68mm Bolt (56) with grease.
Attach the Leg Lever (3) to the Front Leg (2) with
the Bolt and an M10 Nylon Locknut (48).
Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
7. Attach the Backrest Tubes (12) to the Backrest
Bracket (10) with four M6 x 40mm Bolts (40), four
M6 Washers (50), and four M6 Nylon Locknuts
(52).
52
52
10
40
12
50
50
50
50
40
10
41
48
Lubricate
1
7
8
5
5. Attach the Bench Frame (1) to the center holes in
the Crossbar (4) with two M10 x 82mm Bolts (43)
and two M10 Nylon Locknuts (48).
Tighten the M10 Nylon Locknuts (48) used in
steps 1–5.
48
1
43
43
4
Center
Holes
12