Wells F-49 User Manual

Page 6

Advertising
background image

AGENCY LISTING INFORMATION

STD 4

E6070

INSTALLATION

NOTE: DO NOT discard

the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE
on the
inside front cover of this
manual.

IMPORTANT:

This installation must comply
with all applicable Federal,
Local and NFPA codes.


UNPACKING & INSPECTION

Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from the
Appliance before connecting electrical power or otherwise performing
any installation procedure.

Carefully read all instructions in this manual and the Installation
Instruction Sheet
packed with the appliance before starting any
installation.

Read and understand all labels and diagrams attached to the
appliance.

Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.

COMPONENTS
1 ea. FRYPOT
2 ea. FRY BASKETS
4 ea. ADJUSTABLE LEGS

SETUP

Setup the appliance only on a firm, level, non-combustible surface.
Verify local codes for requirements. Concrete, tile, terrazzo or metal
surfaces are recommended. Metal over combustible material may not
meet code for non-combustible surfaces.

Install one adjustable leg at each corner of the fryer by screwing the leg
into the fitting on the bottom. With a spirit level, check that the appli-
ance is level front-to-back and side-to-side. Verify that the unit sits
firmly ON ALL FOUR LEGS.
The lower portions of the legs are adjustable by turning; adjust as
required to level the appliance. All four legs must be adjusted to firmly
contact the counter in order to prevent tipping.

Refer to the Installation Instruction Sheet for required clearances.
Maintain required clearances between the appliance and adjacent
combustible surfaces.

Avoid storing flammable or combustible materials in, on or near the
appliance.

This appliance conforms to NSF Standard 4 for sanitation only if
installed in accordance with the supplied Installation Instructions and
maintained according to the instructions in this manual.

This appliance is

U

Listed under UL File E6070 for 120V, 208V and

240V.

4

Fig. 2 Adjustable Legs

Advertising
This manual is related to the following products: