Weider WEBE03690 - Manual (Page 8)

8
9
10
8. Attach a 30mm x 25mm Bumper (26) to the indicated
hole in the Main Frame (1) with a Bumper Screw (25).
Press a 25mm x 50mm Inner Cap (14) into each end
of the Seat Frame (5).
Important: The Seat Frame (5) has two welded
tubes. Tube A goes through the Seat Frame itself,
and tube B is welded underneath the Seat Frame.
Do not confuse these two tubes in the following
step.
Line up tube A in the Seat Frame (5) with the upper
hole in the bracket on the Main Frame (1). Insert the
M10 x 95mm Bolt (20) through the bracket and the
welded tube in the Seat Frame. Secure the Bolt with
an M10 Nylon Locknut (18).
Note: The Locking Pin w/Ring (30) can be inserted
through tube B to prevent the Seat Frame (5) from
pivoting.
9. Attach the Seat (9) to the brackets on the Seat Frame
(5) with four M6 x 16mm Screws (15).
10. Press a 19mm Round Inner Cap (13) into each end of
the Short Pad Tube (31) and the Long Pad Tube (12).
Mount the Long Pad Tube (12) in the hole in the Seat
Frame (5) in the following manner: Slide a Plastic
Spacer (32) and a Foam Pad (11) onto one end of the
Pad Tube. Slide the Pad Tube through the hole in the
Seat Frame. Slide a Plastic Spacer (32) and a Foam
Pad (11) onto the other end of the Pad Tube.
Mount the Short Pad Tube (31) in the hole in the
sidearm on the Leg (6) by following the instructions
given above.
30
1
14
25
26
14
5
9
20
8
31
32
6
11
11
32
32
32
5
13
12
13
Welded
Tube A
Welded
Tube B
Bracket
15
15
15
15
18
5