Williams Sound Personal PA Receiver PPA R35N User Manual
Page 6
I
NSTALLING AND
R
EPLACING
B
ATTERIES
1. Open the battery compartment by lifting the tab on the back of the receiver with
a finger.
2. To remove depleted batteries, pull up on the fabric strip.
3. If Alkaline (non-rechargeable) batteries are being installed, slide the
battery selection switch above the battery compartment to the “Alkaline”
position. If installing NiMH (or rechargeable) batteries, slide the battery
selection switch to the “NiMH” position.
4. Press the batteries into place over the fabric strip. Be sure to observe proper
polarity (+/–). Damage due to improper battery installation may void the
warranty on the product. Close the lid.
5. When the sound becomes weak or distorted, replace or recharge batteries.
B
ATTERY
C
HARGING
Rechargeable batteries must be charged overnight before first time use. Drop-in
charger points are located on the bottom of the R35 unit. For charger availability,
please contact Williams Sound at (800) 843-3544.
C
HANNEL
T
UNING
First, set the transmitter to the desired channel. Remove the antenna and connect an
audio source. Move the receiver 25 feet away from the transmitter for tuning. Open
the battery compartment on the R35 by lifting the tab on the back of the receiver
with a finger. Locate the metal tuning slug above the batteries next to the “Channel
Tuning” label. Using a small screw driver or tuning wand, turn the tuning slug in a
counter-clockwise direction about two turns. Then, slowly turn the tuning slug in
the clockwise direction until the signal is heard. There may be two signal points
heard. The one which is received first is a false response. Be sure to continue tuning
slightly further to the correct point, which will be much louder. Tune back and forth
to find the center of the point of best response to the program being heard.
FRM 452E ©2007 Williams Sound Corp.