Wind Crest CTI304D - Manual

Page 1 of 8 11067.00 Rev B
INSTALLATION INSTRUCTIONS
ELECTRIC COOKTOP MODELS: CTI304D, CTI365D
IMPORTANT:
Save these instruction for Local Electrical Inspector’s use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
OWNER: Please retain these instruction for future reference.
READ AND SAVE THESE INSTRUCTIONS
Before beginning, please read these instruction completely and carefully.
WARNING
– TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
1. Use This Unit Only In The Manner Intended By The Manufacturer. If You Have Any Questions, Contact
The Manufacturer.
2. Before Installing Or Servicing Unit, Switch Power Off At Service Panel And Lock Service Disconnecting
Means To Prevent Power From Being Switched On Accidentally. When The Service Disconnecting Means
Cannot Be Locked, Securely Fasten a Prominent Warning Device, Such As A Tag, To The Service Panel.
POWER SUPPLY
– Power supply is dual rated: 240 VAC /208 VAC, 3-wire, 60 Hz, 50Amp circuit breaker
required for CTI365D Models and 30 Amp circuit breaker for CTI304D Models.
JUNCTION BOX
– Plan the installation of the unit so that the location of the junction box is within three (3)
feet of the center bottom of the cooktop. The junction box must be accessible from the
front of the unit. See FIG
– 4.
CABINET PREPARATION AND CLEARANCE
– Be sure your appliance is properly installed and
grounded by a qualified technician.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a
range hood that projects horizontally a minimum of 5 inches beyond the bottom of the cabinets.