Western Digital WD ShareSpace User Manual
Page 5
WD ShareSpace | 3
Step 1: Connect WD ShareSpace to the Network
1. Connect one end of the Ethernet cable into the Ethernet port located on the back of the unit.
2. Connect the other end of the Ethernet cable directly into a router or network switch port.
3. Connect the end of the adapter into the DC power supply socket located on the back of the unit.
4. Plug the AC adapter into an electrical outlet. The unit starts to power up as soon as power is
applied. When power-up is complete, the LED on the power button displays a steady green light
.
Power Button
The power button turns the device on or off. To turn on the device, press the power button and hold
down until the LED flashes once, then release. The LED remains off (up to 30 seconds) as the device
powers up. Holding the button down for four seconds powers off the device.
Important: Wait for the WD ShareSpace to finish powering up (approximately three minutes)
before configuring the device. During this time, do not press the power button.
WD_ShareSpaceQIG.book Page 3 Tuesday, March 31, 2009 12:02 PM