weber S-660TM - Manual (Page 26)

26
WWW.WEBER.COM ®
LOCATING YOUR LP TANK ENCLOSURE KIT
When determining a suitable location for your LP Tank Enclosure Kit installation, give
attention to concerns such as proximity to traffic paths, and keeping any gas supply
lines as short as possible. Never locate the Summit
® LP Tank Enclosure Kit in a garage,
breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the LP
Tank Enclosure Kit and structure so there is enough room to safely evacuate the area in
case of a fire.
c
b b
1
1 1
a
CLEARANCE FROM COMBUSTIBLE SURFACES OR
STRUCTURES
ƽ WARNING: Clearance from the outside walls of the sides
and back of the LP Tank Enclosure must be a minimum of
24" (60.96cm) any surface. Refer to “Typical Gas Supply
Installation” before starting installation.
ƽ WARNING: The structure, “island” counter tops and adjacent
work areas for the LP Tank Enclosure must be built from
noncombustible materials only.
NOTE: If you have questions on what materials are considered noncombustible, contact
you local building supplier or fire department.
ƽDANGER
Use of any other hose and regulator assembly could be
dangerous, and may not provide adequate gas supply to
the Summit
® Built-In gas grill, and could result in a fire or an
explosion causing serious bodily injury or death and damage
to property.
ƽ DANGER
Failure to build a LP cylinder enclosure for a 20 lb cylinder
following the requirements for ventilation, cylinder retention
and separation of the LP cylinder from a heat source, listed in
the ANSI Standard for Outdoor Cooking Gas Appliances, ANSI
Z21.58 CSA 1.6, could be dangerous, and could result in a fire
or an explosion causing serious bodily injury or death and
damage to property.
If you do not follow the DANGER statements exactly, the Warranty on the Summit ®
Built-In gas grill will be voided.
ENCLOSURE CHART
1 24˝ inches (610 mm) Any Surface
a LP Tank Enclosure
b Any Surface
c Non-Combustible Surface
BUILT-IN TANK ENCLOSURE INSTRUCTIONS