WatchGuard Technologies V10 - Manual (Page 19)

Front and Back Views
Firebox V10, V60L, V60, V80, V100 Hardware Guide 9
passes. These interfaces are multi-mode, but they
do not support 10/100 communications.
On each side of the two Gigabit interfaces are three
LEDs labeled RX, TX, and Link.
The Link LED is lit when a connection is active.
The RX LED blinks steadily when data packets are
being received by the appliance.
The TX LED blinks steadily when data packets are
being transmitted.
High Availability Status LED
Indicates the current status of this appliance, if it is
one of two connected as a high-availability system.
If this is the primary appliance, and the light is on
and steady, the system is functional, and this
appliance is online. If this is the primary appliance
and the LED is blinking, a failover has occurred
and the secondary appliance is online.
For more information on HA setup, see the Firebox
Vclass User Guide.
High Availability Interfaces
Two Ethernet interfaces, labelled HA2 and HA1
enable you to connect with a cross-over Ethernet
cable to other High Availability-ready Firebox
Vclass appliances for failover (backup) protection.
Incorporated into the two high-availability
Ethernet ports are two indicator lights labeled 10
and 100. These LEDs indicate the speed traffic is
transmitted.
Console Interface
A single RJ-45 interface, labelled Console, supports
a direct workstation-to-appliance connection. You
can use the WatchGuard Command Line Interface
(CLI) to administer and test this appliance. To learn
more about this administrative option, see the CLI
Guide included on the installer CD.