Wolf Appliance Company PWC482418R - Manual (Page 16)

D E C O R A T I V E R A I L
Clean the decorative hood rail using warm
soapy water. Then hand dry with a clean,
soft cloth.
It is not necessary to remove the decorative
rail from the hood assembly. It should be
cleaned in place.
Be careful not to pull or hang on the bar, as
this could damage the hood assembly.
S T A I N L E S S S T E E L F I N I S H
Use a soft, nonabrasive stainless steel cleaner
like Signature Polish (see side note) and apply
with a soft lint-free cloth. To bring out the
natural luster, lightly wipe the surface with a
water-dampened microfiber cloth, followed
with a dry microfiber cloth. All work should
follow the same grain direction as the finish.
Best results are obtained by keeping the cloth
in continuous contact with the metal.
16
W O L F P R O V E N T I L AT I O N H O O D U S E & C A R E
C L E A N I N G A N D C A R E
Most surfaces of your Wolf Pro hood are
stainless steel. Although resistant to most
stains, it is not totally impervious to damage.
G E N E R A L C L E A N I N G
Salt and some cooking liquids may pit and
stain the surface. Always remove any film
or spills immediately.
Avoid using abrasive cleaners. They will
permanently scratch the surface.
Do not use steel wool pads.
Be careful not to soak the rotary switches.
Although they are sealed, excessive
moisture may cause damage to the
controls.
A spray degreaser will remove fingerprints
and greasy spatters. Spray on a cloth and
wipe surface. Buff dry immediately to avoid
streaking.
Use white vinegar and water to remove
hard water stains.
Use a clean cloth or sponge, wipe with
warm water and mild detergent. Rinse and
dry immediately.
Apply a protective polish like Signature
Polish (see side note) to the surface to
maintain luster and protect against food
stains. Apply the polish following the same
grain direction as the finish.
S I G N A T U R E
P O L I S H
Signature Polish
is available from
Signature Limited
Laboratory,
P. O. Box 13436,
Dayton, Ohio
45413-0436, or
call 877-376-5474
(toll free).
Under no circumstances should you use a
metallic or highly abrasive cleaner or
cloth, as this will damage the finish.