Wells WVG-136RW - Manual (Page 19)

CLEANING INSTRUCTIONS (continued)
CAUTION:
Electric Shock
Hazard
Disconnect appliance from
electric power before
cleaning.
CAUTION:
Hot Surface
Exposed surfaces
can be hot to the touch
and may cause burns. Allow
appliance to cool before
cleaning.
IMPORTANT:
Never allow PRE-FILTER or
FILTER PACK to get wet.
DO NOT wash either of these
two filters. Washing these
filters will ruin them and cause
the appliance to shut-down.
IMPORTANT:
DO NOT spill or pour water
into controls, control panel,
wiring or coil-type hotplate
elements. Damage to internal
components will occur.
Damage to internal
components from water
damage is not covered by
warranty.
IMPORTANT:
DO NOT use steel wool or
metal implements to clean
drawers or cabinet surfaces.
VENTILATOR WEEKLY CLEANING
ROLL WARMER WEEKLY CLEANING
PREPARATION: Disconnect appliance from electric power
Allow to cool before cleaning
FREQUENCY: Weekly
TOOLS: Warm water and a mild detergent
Soft clean cloth or sponge
Bristle brush
Container for disposal of grease
VENTILATOR SECTION
Remove the grease baffle, pre-filter assembly, grease trough and
grease cup. Empty the grease trough and grease cup.
Remove the pre-filter from the filter frame. Wash and rinse the
filter frame ONLY.
Wash and rinse the grease baffle, grease trough and grease cup in
a sink or dishwasher using mild detergent and warm water. Allow
to air dry.
Reinsert the pre-filter into the filter frame. Reinstall the pre-filter,
grease baffle, grease trough and grease cup.
ROLL WARMER SECTION
Remove roll warmer drawers, drawer inserts and Humitrol racks.
Brush crumbs from drawer slides and interior of warmer cavity with
a bristle brush.
Wash and rinse the drawer inserts and Humitrol racks in a sink or
dishwasher using mild detergent and warm water. Allow to air dry.
Reassemble and reinstall warmer drawers.
Procedure is complete
17