Wolverine Siding and Vinyl Carpentry Soffit and Decorative Trim - Manual (Page 112)

Repeat until both sides of the sunburst are completed.
NOTE: To install the final panels at the top of the
sunburst, bow the panels slightly and slip them under the
gable end J-channel. For added protection against high
wind, you may have to face nail these panels.
Form a sleeve from aluminum coil stock and cover the center
J-channels. Secure with pop rivets.
Cut an arched section from coil stock to form the “sun”
portion of the sunburst. Leave a 1" strip below the arch and
bend out at a right angle. Fasten the piece in place using pop
rivets.
111
Wolverine Fit and Finish Installation Guide