Weider WEBE15100 - Manual (Page 8)

8
7. Press four 1Ó Square Inner Caps (12) into the
Backrest Tubes (5, 55). Press two 1Ó x 2Ó Inner
Caps (45) into the adjustment tubes.
With the wide end of the Backrest (6) positioned
as shown, attach the Backrest Tubes (5, 55) to
the Backrest (6) with four M6 x 38mm Screws
(16) and four M6 Washers (25). The Backrest
Tubes and Backrest must be oriented exactly
as shown.
8. Lubricate the M10 x 178mm Bolt (17). Attach the
Backrest Tubes (5, 55) to the Frame (2) with the
Bolt, two M10 Washers (24), and an M10 Nylon
Locknut (19). Do not overtighten the Locknut. The
Backrest must be able to pivot freely.
Secure the Backrest Tubes (5, 55) to the Frame
(2) by inserting the Adjustment Pin (40) through
one of the three sets of holes in the adjustment
tubes. Secure the Adjustment Pin with the Pin
Clip (57).
Make sure the Adjustment Pin (40) is com-
pletely inserted through both adjustment
tubes.
9. With the wide end of the Seat (11) positioned as
shown, attach the Seat to the brackets on the
Frame (2) with four M6 x 16mm Screws (15).
16
25
55
5
12
12
16
45
6
Wide
End
7
2
57
40
5
55
Adjustment
Tubes
6 8
2
11
Wide
End
15
28
27
15
9
10
10. Attach the Curl Pad (28) to the Curl Post (27) with
two M6 x 16mm Screws (15).
25
Adjustment
Tubes
17ÑLubricate
24
19
25
16