Westell Technologies 2110 - Manual (Page 9)

030-300224 Rev. A 7
WireSpeed Dual Connect Modem User Guide
Figure 2. Modem Connection via USB
5.6.2
Modem Installation via 10/100 Base-T/Ethernet
Note: Before you connect the modem via 10/100 Base-T, you must have an available Ethernet card installed in your computer. If your
Ethernet card does not auto-negotiate, you must set it to half duplex. Refer to the Ethernet card manufacturer’s instructions for
installing and configuring your Ethernet card.
Refer to Figure 3.
1. Verify that you have an available Ethernet card. Note: See the above caution box.
2. Connect the power supply cord to the power connector marked
~
on the rear panel of the modem. Plug the
other end of the power supply cord into an AC wall socket.
3. Connect the DSL phone cable from the jack on the rear panel of the modem marked to the DSL-equipped
telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must use the
phone cord that was provided with the modem kit.
4. Connect the yellow Ethernet cable from the Ethernet jack marked on the rear panel of the modem to the
Ethernet port on your computer.
!
12V