Weider C670 - Manual (Page 17)

17
34. Locate the Butterfly Cable (109). Attach the
Cable to the Left Butterfly Arm (57) with an M8 x
43mm Shoulder Bolt (107), an M10 Small Washer
(95), and an M8 Nylon Locknut (108).
36. Wrap the Butterfly Cable (109) under a Pulley
(87). Attach the Pulley to the Double “U”-bracket
(81) with an M10 x 45mm Bolt (33) and an M10
Nylon Locknut (34).
38. Attach the Butterfly Cable (109) to the Right
Butterfly Arm (56) with an M8 x 43mm Shoulder
Bolt (107), an M10 Small Washer (95), and an M8
Nylon Locknut (108).
35. Wrap the Butterfly Cable (109) over a “V”-pulley
(86). Attach the “V”-pulley and a Large Cable
Trap (111) to the bracket on the Center Upright
(45) with an M10 x 60mm Bolt (105) and an M10
Nylon Locknut (34). Make sure the Cable Trap
is oriented to hold the Cable in the groove of
the Pulley.
37. Wrap the Butterfly Cable (109) over a “V”-pulley
(86). Attach the “V”-pulley and a Large Cable
Trap (111) to the other side of the bracket on the
Center Upright (45) with an M10 x 60mm Bolt
(105) and an M10 Nylon Locknut (34). Make sure
the Cable Trap is oriented to hold the Cable in
the groove of the Pulley.
34
107
108
95
109
57
35
86
105
109
111
34 45
37
38
86
105
109
111
34
45
36
87
109
81 33
107
108
95
109
56
34