Windsor Clipper CLP12IB - Manual (Page 20)

MAINTENANCE
86038280 04/04/07 4-2ENG
SOLUTION PUMP REPLACEMENT
1. Turn off all switches and unplug the machine.
2. Remove recovery tank.
3. Remove the (2) screws that fasten the solution tank to the frame, and tilt tank back to expose the inside
of the frame.
4. Remove solution hoses from fittings in pump.
5. Remove the (2) screws that fasten the pump to the frame.
6. Reverse process to install pump.
ONLY QUALIFIED MAINTENANCE PERSONNEL ARE TO PERFORM THE
FOLLOWING REPAIRS.
BELT REPLACEMENT
1. Turn off all switches and unplug machine.
2. Remove recovery tank and brush.
3. Remove the (2) screws that fasten the solution tank to the frame, and tilt tank back to expose the inside of the
frame.
4. Loosen the (4) screws that hold the brush motor in place and slide motor forward to release tension in belt.
5. Remove the (2) screws that fasten the vacuum shoe links (86227350 - PRV NO. 05016) to the brush housing.
6. Remove the (3) screws that fasten the side plate (86249420 – PRV NO. 62759) to the brush housing to
remove belt. NOTE: All components associated with driving the brush will come out with the side plate.
7. Reverse process to install belt.
86249420
PRV NO. 62759
86227350
PRV NO. 05016
Pressure Switch
86161980
PRV NO. 42-809332 Valve Asm
86258830 - PRV NO. 84161
Diaphram
86235100 - PRV NO. 29206
Pump Replacement Parts for Shurflo 100 psi (86026400 – PRV NO. 65254)
Pump Head
86251040
PRV NO. 65187
Motor
86247370 - PRV NO. 53246
Diaphragm
86235120 - PRV NO. 29219
Pump Head
86251090 – PRV NO. 65204
Valve Asm
86258860 - PRV NO. 84166
Pump Replacement Parts for Flojet 100 psi 230v (86004770 – PRV NO. 47477)