Westcott 2134 - Manual (Page 2)

Light Modifiers
Page 2 of 2
Questions? Please call 800.886.1689 or email [email protected] . ©F.J. Westcott Company
For indirect diffusion of light, purchase an optional Reflector Plate (#2875). The anodized aluminum
plate is mounted on the center shaft just in front of the flash tube. This allows the light to bounce off the
reflector plate, into the silver metalized material and then out through the diffuser panel. The Reflector
Plate can be adjusted along the center shaft closer or further from the flash tube to control the amount of
light that is reflected off the silver interior of the Halo
™.
Because of their parabolic shape, Halo
™ light modifiers are measured diagonally.
Westcott Halo
™ styles that are available and recommended wattage:
#2025 45” Round Halo
™
500W
#2026 45” Round Halo
™ Mono
500W
#2034 54” Round Halo
™ Mono
1000W
#2134 40” x 50” Ed Pierce Edition Halo
™
1000W
Accessory for Halo
™Mono
#2875 Internal Reflector Plate
The (#2134) Ed Pierce Edition Halo, (#2034) Round Halo
™ Mono, have a non-standard 3/8” umbrella
shaft compared to the standard 5/16” diameter umbrella shaft. If the umbrella receptacle on the light
does not accommodate this large of a shaft, an umbrella adaptor may be purchased at your Westcott
Dealer.