Waves Trans-X - Manual (Page 7)

Waves Trans-X software guide page 7 of 8
R ELEASE : 0.50 to 500ms. Default:10.02ms.
This is the release time for the gain adjustment. Once the detected transient is
over, this is the time it will take the gain adjustment to settle back to 0dB. The
release is actually not completely linear and in the multiband it is even scaled
differently for each band.
O
UTPUT
: +18dB to –18dB. Default: 0dB.
The Output fader is located between the output meters and adjusts the gain of
the overall output of the Trans-X.
T
RIM
: Click to Trim.
The Trim control is located between the clip indicators and shows the number
that is the difference between the peak energy and the full digital scale or
0.0dBfs. When you click the Trim control, it will adjust the output gain by the
indicated value. For example, if the Trim box indicates 3.2dB below full scale,
then clicking it will increase the current output gain by 3.2dB. This is
convenient for setting the best level for the plug-in output without clipping it.
Multiband Only: Per band O
N /O FF : Default: On.
This will turn the Transient processing on and off for the related band.