Weider WEBE08900 - Manual (Page 9)

9
12. Press a 45mm Square Inner Cap (28) into the top
of the Lat Tower (11). Route the Cable (25) around
the Pulley (26) as indicated. Slide the Pulley into
the slot of the Lat Tower and attach it with an M10 x
64mm Bolt (46), two M10 Flat Washers (54), two
M10 Spacers (42), and an M10 Nylon Locknut (45).
Do not overtighten the Nylon Locknut. The
Pulley must be able to turn freely. Attach the
Cable Clip (35) to the end of the Cable.
12
13. Slide the Lat Tower (11) into the Front Leg (2).
Tighten it in place with the Short Adjustment Knob
(27).
13
28
11
42
54
46
26
42
54
45
25
35
27
2
11
11. Press a 1Ó Round Inner Cap (21) into the weight
tube of the Weight Carriage (12). Slide a Weight
Stop (34) onto the weight tube. Press a 2 1/2Ó
Square Bushing (23) onto each end of the Weight
Carriage (12).
Slide an M10 x 19mm Bolt (44) into the bracket on
the Weight Carriage (12). Slide the Weight Carriage
onto the Lat Tower (11).
Thread the Cable (25) through the slot of the Lat
Tower (11) in the direction indicated. Connect the
end of the Cable without the ball to the Weight
Carriage (12) using the M10 x 19mm Bolt (44) and
an M10 Nylon Locknut (45).
11
Weight
Tube
Slot
Ball
Bracket
25
45
44
34
21
12
23
23
11
10. Attach the Backrest (15) to the Backrest Tubes (20)
using four M6 x 38mm Screws (14) and four M6
Flat Washers (51).
Make sure that the Backrest (15) is oriented so
that there is a gap between the Backrest and the
Seat (16).
10
51
20
15
16
14
14 51