Weider WESY19541 - Manual (Page 6)

6
2. Attach the Base (1) and the two Weight Guides
(21) to the Stabilizer (2) with two M10 x 67mm
Bolts (71), two M10 Washers (57), and two M10
Nylon Locknuts (56).
Make sure the indicated
holes in the Weight Guides are nearer the
bottom. Fully tighten the Locknuts.
Attach the Upright (3) to the Base (1) with the two
indicated M8 x 63mm Carriage Bolts (87) and two
M8 Nylon Locknuts (58).
Do not tighten the
Locknuts yet.
1.
Insert four M8 x 63mm Carriage Bolts (87) up
through the Base (1).
Note: It may be helpful to
place a piece of tape over the bolt heads to
hold them in place.
Before beginning assembly, make sure you
understand the information in the box on
page 5. Refer to the PART IDENTIFICATION
CHART in the center of this manual for help
identifying small parts.
Frame Assembly 1
1
87
87
2
87
56
58
3
1
58
71
71
2
57
57
21
Holes
21