Wayne-Dalton 9100 - Manual (Page 20)

Tools Needed:
20
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
TorqueMaster ® Spring Tube
TorqueMaster ® springs come lubricated
and pre-assembled inside the
TorqueMaster
® spring tube. To install, lay
the TorqueMaster ® spring tube on the
fl oor (inside garage) in front of the door
with the labeled end to the left.
LABELED END
TORQUEMASTER ®
SPRING TUBE
None
17
18
Center Bracket Bushing
NOTE: If you are installing the idrive ®
opener on your garage door, skip this
step and continue with Step 19.
NOTE: If you are not installing the
idrive
® opener on your garage door, you
must install the center bracket bushing
assembly. Follow these instructions for
non-idrive
® operated garage doors.
NOTE: If you are installing a
DoorMaster
™ opener, see optional
DoorMaster ™ Bracket installations on
page 32, Figure A.
Being cam shaped the center bracket
bushing only fi ts one way.
Slide the center bracket assembly
towards the center of the TorqueMaster
®
spring tube, from the right side as
shown.
NOTE: Upon completion of this step,
continue with Step 20.
CENTER
BRACKET
ASSEMBLY
TORQUEMASTER ®
SPRING TUBE
TORQUEMASTER ®
SPRING TUBE
CENTER
BRACKET
BUSHING