Weslo WLEVEX12920 - Manual (Page 10)

10
3. Measure your heart rate, if desired.
To measure your
heart rate, stop
pedaling and
place your thumb
on the pulse sen-
sor as shown. Do
not press too
hard, or the cir-
culation in your
thumb will be
restricted and
your pulse will
not be detected.
After a few seconds, the heart-shaped indicator in
the display will flash steadily, two dashes will
appear, and then your heart rate will be shown.
Hold your thumb on the pulse sensor for about 15
seconds for the most accurate reading.
If the displayed heart rate appears to be too high or
too low, or if your heart rate is not displayed, lift
your thumb off the pulse sensor for a few seconds.
Then, place your thumb on the pulse sensor as
described above.
Make sure you are applying the proper amount of
pressure to the pulse sensor. Try the pulse sensor
several times until you become familiar with it.
Remember to sit still whilst measuring your heart
rate.
4. To reset the display at any time, press the
ON/RESET button.
5. To turn off the power, simply wait for a few minutes.
The console has an “auto-off” feature. If the
pedals are not moved and the console buttons
are not pressed for a few minutes, the power
will turn off automatically to save the batteries.
WARNING:
The pulse sensor
is not a medical device. Various factors
may affect the accuracy of heart rate read-
ings. The pulse sensor is intended only as
an exercise aid in determining heart rate
trends in general.
Pulse Sensor