Weslo WLTL35520 User Manual
Page 7
7
9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 14). To protect the floor or carpet, place a mat under the treadmill.
8. Attach the Storage Latch (14) to the left Upright (76) with
two 3/4” Screws (13).
Be careful not to overtighten the
Screws.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 12), but do not
latch it. Make sure that the frame is centered between
the Handrails (1, 47 [not shown]). Firmly tighten all of
the bolts and screws used in assembly steps 3, 4, 5,
and 6. Then, lower the frame to the floor.
13
14
1
76
46
96
Ties
47
6
46
10
21
6. Place the Console Base (46) on the Right Handrail (47)
and the Left Handrail (not shown). Attach the Console
Base with four 1 1/4” Screws (105) (only two Screws are
shown).
Do not tighten the Screws yet.
Insert the Wire Harness (21) through the two indicated
plastic ties on the Console Base (46). Next, insert the
Wire Harness up through the indicated opening in the
Console Base. Make sure that the Console Cover (96) is
securely attached to the Console Base.
Refer to the inset drawing. Look at the top of the Console
Base (46). Insert the Wire Harness (21) through the plas-
tic tie on top of the Console Base.
7. Hold the Console (10) near the Console Base (46).
Touch
the Right Upright (62) to discharge any static. Plug
the widest connector on the Wire Harness (21) into the
widest connector on the Console. If the connector does
not fit easily, rotate it and then connect it. Plug the
other connector on the Wire Harness into the other con-
nector on the Console. Insert the excess Wire Harness
down through the opening in the Console Base. Refer to
the inset drawing in step 6 above. Securely tighten the
plastic tie on top of the Console Base to prevent the
Wire Harness from slipping. Then, cut off the end of the
plastic tie.
Set the Console (10) on the Console Base (46). Insert the
excess Wire Harness (21) into the large hole in the side
of the Right Handrail (47). Securely tighten the plastic
ties on the bottom of the Console Base to prevent the
Wire Harness from slipping. Then, cut off the ends of the
plastic ties.
Attach the Console (10) to the Console Base (46) with two
1/2” Silver Screws (97) and four 3/4” Screws (13). Start all
six Screws before tightening them; do not over-
tighten the Screws.
7
8
21
21
Tie
46
105
62
97
13
13
47
Ties