Weslo WLSG62810 - Manual (Page 9)

9
4. Remove the two warning decals (not shown) from
the spa shell. Using a damp cloth, wipe the spa shell
clean. Before filling the spa, make sure that it is
in the desired position and that there is room to
service the spa. Once the spa is filled, it will
have to be drained before it can be moved.
Insert a garden hose into the filter housing, and
begin filling the spa. Do not use soft water. The
spa may be filled with cold water; however, if warm
or hot water is used, the spa will be ready for use
sooner. Fill the spa until the water is at the level of
the molded fill line. Do not overfill the spa.
Refer to the inset drawing. Set the Filter (5) in the
filter housing. Screw the Filter Cover (3) into the fil-
ter housing until it is fully seated.
3. The hydrotherapy spa operates on a 240-volt power source and must be wired directly to a 30 amp Ground
Fault Circuit Interrupter (GFCI) installed in your home. This procedure must be performed by a qualified,
licensed electrician. A wiring diagram is found on the inside of the electronics package for reference.
Under no circumstances should the spa be wired by someone other than a qualified electrician. Before
you have the spa wired, make sure it is in the desired position, and that it can be easily serviced, if needed.
5. Pull down one of the straps on the Spa Cover (11)
and hold the Buckle (26) against one of the premium
cedar panels on the spa. (Note: To position the Buckle
correctly, have a second person hold the strap on the
opposite side of the Spa Cover snug.) The Spa
Cover must be snug. Do not place the Buckle over
the grooves between the premium cedar panels.
Refer to the inset drawing. Remove the latch from the
Buckle (26). Attach the Buckle to the premium cedar
panel with two #4 x 3/4” Screws (27).
Attach the other three Buckles (26) to the premium
cedar panels in the same way.
Remove the Spa Cover (11) from the spa.
4
Fill to Here
Garden Hose
Filter
Housing
5
11
26
Strap
Strap
Latch
26
27
3
5
Filter
Housing