weber 55204 - Manual (Page 24)

C-5
Install control panel and burner control knobs
You will need: control panel, two Phillips screws/
washers, a Phillips screwdriver, and burner control
knobs.
1) Set the control panel in place over both frame
braces. Hold the Crossover Ignition button up
while setting the control panel in place.
2) While looking under the right trim piece push the
control panel down and line up the holes in the
control panel with the white plastic plugs in the
frame brace. Insert screws and tighten with a
phillips screw driver until snug. Do not over
tighten.
3) Push each of the burner control knobs onto their
valve.
(1)
(2)
(3)
Install Flavorizer® Bars and Cooking Grates
You will need: five Flavorizer Bars and two cooking
grates.
Place the Flavorizer Bars side by side in the cooking
box.
Set the cooking grates onto the ledges in the cooking
box with the rounded sides up.