Weider Pro XT20 WEBE09101 - Manual (Page 8)

8
7. Press three 45mm Square Inner Caps (17) into the
Leg Lever (18). Press a 25mm Round Inner Cap
(33) into the indicated end of the Weight Tube (21).
Attach the Weight Tube (21) to the Leg Lever (18)
with an M8 x 58mm Bolt (16), two M8 Flat Washers
(13), a 10mm Spacer (20), and an M8 Nylon
Locknut (9). Press an Angled Outer Cap (31) onto
the back end of the Weight Tube.
7 17
17
21
33 17
16
20
13
18
13
9
31
9. Press two 3/4” Round Inner Caps (12) into each of
the three Pad Tubes (25). Slide the Pad Tubes into
the indicated holes in the Front Leg (19) and the
Leg Lever (18).
Slide two Foam Pads (10) onto each Pad Tube (25).
10. Attach the Curl Pad (26) to the Curl Post (32) with
two M6 x 16mm Screws (3). Insert the Curl Post
into the Front Leg (19) and secure it with the Curl
Post Knob (36).
9
10
25
25
12
19
18
12
12
26
19
32
3
36
12
10
10
10
10
8. Lubricate an M10 x 68mm Bolt (39). Attach the Leg
Lever (18) to the Front Leg (19) with the Bolt and
an M10 Nylon Locknut (11).
Do not overtighten
the Nylon Locknut; the Leg Lever must be able
to pivot freely.
8
18
11
19
39
11. Make sure all parts are properly tightened
before you use the weight bench. The use of all
remaining parts will be explained in
ADJUSTMENTS, starting on page 9.