Bosch TCA 5201 - Manual (Page 20)

16
Robert Bosch Hausgeräte GmbH
en
Steam for heating drinks

! Risk of burns
The nozzle gets very hot. Do not touch the
metal parts.
The appliance must be ready for use.
Push the sleeve on the nozzle 8 all the
way up.
Press the steam button h
. The LED will
start to lash.
i
The appliance will now heat up for
approx. 20 seconds.
Immerse the nozzle 8 deep into the liquid
you want to heat.
As soon as the J LED lashes, turn the
dial 6 to g / h .

! Risk of scalding
When the dial 6 is set to
g
/
h
, the nozzle 8
may sputter a little. Escaping steam is very
hot and may cause liquid to sputter. Do not
touch the nozzle 8 or point it at anyone.
End the process by turning the dial 6
back to “O”.
i
To generate more steam, press the steam
button
h
again and repeat the whole
process.
Note: When the nozzle 8 has cooled down,
clean immediately. Dried residue is dificult
to remove.
Maintenance and daily
cleaning

! Risk of electric shock!
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
Always remove any limescale, coffee,
milk or descaling luid residue immedi-
ately. Such residue can cause corrosion.
Wash all removable parts by hand only.
Rinse out the water tank 11 with water
only.
Remove, empty and clean the trays for
coffee grounds 17 and residual water 18.
Wipe out the inside of the appliance (tray
holders).
Open the doors to the brewing unit 21
and remove any coffee residues. Close
the doors.
Note: If the appliance is cold when switched
on, or if it is switched to “eco” mode after
dispensing coffee, it rinses automatically; in
other words the system cleans itself.
Nozzle 8 for hot water/steam
Unscrew the nozzle 8 from the steam
pipe.
Dismantle all parts (Fig. D).
Clean with a caustic cleaning solution and
a soft brush. Clean the tip of the nozzle
8/c with a blunt needle.
Thoroughly rinse and dry all parts.
Brewing unit
The brewing unit can be removed for
cleaning (Fig. E).
Press the eco button to start the
automatic rinse cycle.
Turn the power on/off switch 1 to 0.
Open the door 21 to the brewing unit 22.
Hold the red button 22a down and push
the handle 22b up until you hear it
engage.
Grasp the brewing unit 22 by the handle,
remove carefully, and rinse under running
water. Do not use cleaning agents. Do not
place in the dishwasher.
Vacuum the inside of the appliance, or
clean it with a damp cloth.
Reinsert the brewing unit 22 all the way
into the appliance.
Hold the red button 22a down and push
the handle 22b down as far as it goes,
until you hear it engage. The brewing unit
is now secure.
Close the doors of the brewing unit.