Zanussi ZWFS 7000 - Manual (Page 21)

Unscrew the three bolts. Slide out the relevant plas-
tic spacers.
Open the porthole and re-
move the polystyrene
block fitted on the door
seal.
Fill the smaller upper hole
and the two large ones
with the corresponding
plastic plug caps supplied
in the bag containing the
instruction booklet.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the machine is not impeded by carpets,
rugs etc. Check that the machine does not touch the wall
or other kitchen units. Level the washing machine by rais-
ing or lowering the feet. The feet may be tight to adjust as
they incorporate a self locking nut, but the machine MUST
be level and stable.
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and displace-
ment of the machine during operation. Never place card-
board, wood or similar materials under the machine to
compensate for any unevenness in the floor.
If necessary, check the
setting with a spirit level.
Rubber feet kit (4055126249)
Available from your authorized dealer.
The rubber feet are particularly recommended on floating,
slippery and wooden floors.
Mount the rubber feet to prevent vibration, noises and dis-
placement of the appliance during operation.
Read carefully the instructions supplied with the kit.
Water inlet
Caution!
• This appliance must be connected to a cold water
supply
• Before connecting up the appliance to new pipe-
work or to pipework that has not been used for
some time, run off a reasonable amount of water
to flush out any debris that may have collected
• Do not use the hose from your previous appli-
ance to connect to water supply.
The inlet hose is supplied and can been found inside the
machine drum.
35°
45°
Open the porthole and extract the inlet hose.
Connect the hose with the angled connection to the ma-
chine. Do not place the inlet hose downwards. Angle
the hose to the left or right depending on the position of
your water tap.
Set the hose correctly by loosening the ring nut.
Connect the hose to a tap
with a 3/4” thread.
21