Yamaha CDX-490 - Manual (Page 11)

11
When you listen with headphones
Connect the headphones to the PHONES jack and adjust the
volume by using the OUTPUT LEVEL button. At that time,
note that this adjustment will also vary the signal level output to
the amplifier.
CDX-890 only
* If the FIXED (LINE OUT) terminals on the rear of this unit
are connected to the amplifier etc., the use of the OUTPUT
LEVEL button will not vary the signal level output to the
amplifier.
Changing brightness of the display
You can change the brightness of the display (or turn off the illumination) by pressing the DIMMER button.
During play
Normal illumination
Dim
“OFF”
* While the display illumination is off,
the AUTO DISPLAY OFF indicator
on the front panel is illuminated.
During stopped or paused
Normal illumination
Dim
Dim
(The AUTO DISPLAY OFF indicator lights up.
In this state, if a disc is played, the display
illumination will be turned off.)
If desired, you can change brightness of the display
in three degrees by pressing the DIMMER button.
Normal illumination
Slightly dim
Dim
Open/close the control door CDX-890 only
When it is not necessary to operate controls inside the control
door, close the door.
To open the door To close the door
English
DIMMER
DIMMER
PHONES
AUTO
DISPLAY OFF
OUTPUT LEVEL – +
CDX-890, CDX-590
CDX-490